Pure Evoke-2 Manuel d'utilisateur télécharger pdf (Page 10)

If no stations are found, you see the message ‘No stations available’ and the display shows an option menu,

see If no stations are found during the autotune on page 6 for details of this menu. Check your aerial is fully

extended and try one of the available tuning options.

Tuning aid - See DAB Tuning aid on page 12 for details of using the tuning aid to improve reception.

Autotune local - See Retuning your unit below for details of the local autotune option.

Autotune full - See Retuning your unit below for details of the full autotune option.

Retuning your unit

You can re-tune your unit at any time using the autotune process. You may wish to do this if a new multiplex is launched

or you move your unit to another room. You do not need to perform an autotune to pick up new stations within a

multiplex you are listening to as your EVOKE-2 monitors and refreshes the list of available stations automatically. The

following two options are available:

Autotune local - scans all frequencies in the UK channel allocation. This should only take a few seconds.

Autotune full - scans the full range of digital frequencies in Band III. This may take a minute or more.

1. Ensure your EVOKE-2 is switched on and the aerial is connected and fully extended.

2. If in FM mode, select DAB mode by pushing the DAB/FM button.

3. Push and release the Autotune button once for local scan or hold down for around two seconds for a full scan.

Note You can cancel Autotune by pushing the Autotune button again during the tuning process.

The display will indicate tuning is underway. When finished, the EVOKE-2 will return to the station you were

listening to and you will hear it through the speakers. All the DAB stations found are now stored in the unit and

you can select another station as described in Selecting a station on page 8.

Tuning in FM mode

Select FM mode using the DAB/FM button. Push the Tune button to switch between manual and seek tuning.

Seek Tuning - turn the Tune knob in the direction you want to search. EVOKE-2 stops at the first station it finds. Repeat

to find the next station.

Manual Tuning - turn the Tune knob until you reach the frequency to which you want to listen. The frequency changes

in steps of 0.05MHz.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Pas de commentaire

Pure Evoke-2 Manuel d'utilisateur Page 10