Pure Evoke-2 Manuel d'utilisateur télécharger pdf (Page 12)

Changing the DAB display mode

EVOKE-2 has six DAB display modes which enable you to view parts of the broadcast DAB data on the bottom line of

the display.

Press the Display button and repeat to cycle through the six different display modes.

Scrolling text The default mode, displays scrolling text messages which accompany the audio, where available.

Program Type A label describing the type of content being broadcast by the service.

Multiplex name Displays the name of the multiplex in which the current service is found, see Guide to Digital Radio

on page 14 for more information on multiplexes.

Date and time Displays the date and time obtained from the current multiplex.

Channel Displays the channel identifier and frequency for the station to which you are tuned, see Guide to

Digital Radio on page 14 for more information.

Mode Displays the mode of the current service, Stereo or Mono and the data rate at which the audio

signal is being transmitted. This rate is set by the broadcaster to suit the type and quality of

material being transmitted.

Signal quality Displays the signal quality for the signal to which you are tuned. As a guide values from 85 to 100

indicate good reception, 70 to 84 borderline reception and 0 to 69 poor reception. You can attempt

to improve this signal quality by adjusting your aerial position using the DAB Tuning aid described

on page 12.

Adjusting the volume and tone

Once you have tuned your EVOKE-2 as explained above you can adjust the volume and tone to your preferred levels.

You use the Volume and Tone controls to adjust these levels.

1. Adjust the volume level using the volume control.

2. Adjust the tone level from low (more bass) to high (more treble).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Pas de commentaire

Pure Evoke-2 Manuel d'utilisateur Page 12